Addition To The Controller Cli - Cisco SD2008T-NA Configuration Manual

Chapter 6 Configuring WLANsWireless Device Access
2.
Figure 6-14 WLANs > New Page
3.
Figure 6-15 WLANs > Edit Page

Addition to the Controller CLI

In release 4.0.206.0, the command for creating a WLAN has expanded to allow the addition of the profile
name in the command.
The config wlan enable wlan_id and config wlan delete wlan_id commands do not require the profile
Note
name to be specified. Their format has not changed.
The new command for creating a WLAN is as follows.
config wlan create wlan_id profile_name ssid
Note
Note
OL-1926-06OL-9141-03
The WLANs > New page, which appears when you click New on the WLANs page to create a
WLAN. Figure 6-14 shows the fields in which to enter the profile name and SSID for the WLAN.
The WLANs > Edit page, which appears when you click Apply on the WLANs > New page or when
you edit an existing WLAN.
If you do not specify an ssid, the profile_name parameter is used for both the profile name and
the SSID.
For releases earlier than 4.0.206.0, the CLI command for creating a WLAN remains as config
wlan create wlan_id ssid.
Figure 6-15 shows the ID, profile name, and SSID of the WLAN.
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
6-31