Cisco SD2008T-NA Configuration Manual page 380

System Messages
Table D-1
Error Message
IPSEC_ESP_INVALID_SPI
IPSEC_OTHER_POLICY_FAILURE
IPSEC_IKE_NEG_FAILURE
IPSEC_SUITE_NEG_FAILURE
IPSEC_INVALID_COOKIE
RADIOS_EXCEEDED
SENSED_TEMPERATURE_HIGH
SENSED_TEMPERATURE_LOW
TEMPERATURE_SENSOR_FAILURE
TEMPERATURE_SENSOR_CLEAR
POE_CONTROLLER_FAILURE
MAX_ROGUE_COUNT_EXCEEDED
SWITCH_UP
SWITCH_DOWN
RADIUS_SERVERS_FAILED
CONFIG_SAVED
MULTIPLE_USERS
FAN_FAILURE
POWER_SUPPLY_CHANGE
COLD_START
WARM_START
Cisco Wireless LAN Controller Configuration Guide
D-4
System Messages and Descriptions (continued)
Appendix D System Messages and LED Patterns
Description
Informational message.
Check for IPSec configuration mismatch between
WLAN and client.
Check for IPSec IKE configuration mismatch
between WLAN and client.
Check for IPSec IKE configuration mismatch
between WLAN and client.
Informational message.
Maximum number of supported Cisco Radios
exceeded. Check for controller failure in the same
Layer 2 network or add another controller.
Check fan, air conditioning and/or other cooling
arrangements.
Check room temperature and/or other reasons for
low temperature.
Replace temperature sensor ASAP.
Temperature sensor is operational.
Check ports — possible serious failure detected.
The current number of active rogue access points
has exceeded system threshold.
Controller is responding to SNMP polls.
Controller is not responding to SNMP polls, check
controller and SNMP settings.
Check network connectivity between RADIUS
and the controller.
Running configuration has been saved to flash -
will be active after reboot.
Another user with the same username has logged
in.
Monitor Cisco Wireless LAN Controller
temperature to avoid overheating.
Check for power-supply malfunction.
Cisco Wireless LAN Controller may have been
rebooted.
Cisco Wireless LAN Controller may have been
rebooted.
OL-9141-03