Cisco SD2008T-NA Configuration Manual page 118

Configuring Voice and Video Parameters
Figure 4-8
Step 4 To enable voice CAC for this radio band, check the Admission Control (ACM) check box. The default
value is disabled.
Note
In the Max RF Bandwidth field, enter the percentage of the maximum bandwidth allocated to clients for
Step 5
voice applications on this radio band. Once the client reaches the value specified, the access point rejects
new calls on this radio band.
Range: 40 to 85%
Default: 75%
In the Reserved Roaming Bandwidth field, enter the percentage of maximum allocated bandwidth
Step 6
reserved for roaming voice clients. The controller reserves this much bandwidth from the maximum
allocated bandwidth for roaming voice clients.
Range: 0 to 25%
Default: 6%
To enable TSM, check the Metrics Collection check box.
Step 7
Click Apply to commit your changes.
Step 8
To enable the radio network, click Network under 802.11a or 802.11b/g, check the 802.11a (or
Step 9
802.11b/g) Network Status check box, and click Apply.
Click Save Configuration to save your changes.
Step 10
Repeat this procedure if you want to configure voice parameters for another radio band (802.11a or
Step 11
802.11b/g).
Cisco Wireless LAN Controller Configuration Guide
4-24
802.11a > Voice Parameters Page
For WMM clients that do not support traffic specifications (TSPEC), disable ACM to allow for
proper QoS mapping.
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-9141-03