Using The Cli To Configure Auto-Anchor Mobility - Cisco SD2008T-NA Configuration Manual

Configuring Auto-Anchor Mobility
Click Save Configuration to save your changes.
Step 5
Repeat
Step 6
Configure the same set of anchor controllers on every controller in the mobility group.
Step 7

Using the CLI to Configure Auto-Anchor Mobility

Use these commands to configure auto-anchor mobility using the CLI.
1.
2.
3.
4.
5.
Cisco Wireless LAN Controller Configuration Guide
11-14
Step 3 and Step 5 to set any other controllers as mobility anchors for this WLAN.
Enter config wlan disable wlan-id to disable the WLAN for which you are configuring anchor
controllers.
To create a new mobility anchor for the WLAN, enter one of these commands:
config mobility group anchor add wlan-id anchor-controller-ip-address
–
config wlan mobility anchor add wlan-id anchor-controller-ip-address
–
The wlan-id must exist and be disabled, and the anchor-controller-ip-address must be a
Note
member of the default mobility group.
Auto-anchor mobility is enabled for the WLAN when you configure the first anchor
Note
controller.
To delete a mobility anchor for the WLAN, enter one of these commands:
config mobility group anchor delete wlan-id anchor-controller-ip-address
–
config wlan mobility anchor delete wlan-id anchor-controller-ip-address
–
The wlan-id must exist and be disabled.
Note
Deleting the last anchor disables the auto-anchor mobility feature and resumes normal
Note
mobility for new associations.
To see the list of controllers configured as mobility anchors for a specific WLAN, enter one of these
commands:
show mobility anchor [wlan-id]
–
show wlan mobility anchor [wlan-id]
–
The wlan-id is optional and constrains the list to the anchors in a particular WLAN. To see
Note
all of the mobility anchors on your system, enter show mobility anchor.
To save your settings, enter this command:
save config
Chapter 11 Configuring Mobility GroupsWireless Device Access
OL-9141-03