Enabling Web And Secure Web Modes; Configuring The Gui For Https - Cisco SD2008T-NA Configuration Manual

4400 series wireless lan controller
Hide thumbs Also See for SD2008T-NA:
Table of Contents

Advertisement

Chapter 2
Using the Web-Browser and CLI Interfaces

Enabling Web and Secure Web Modes

Use these commands to enable or disable the distribution system port as a web port or as a secure web
port:
Web and secure web modes are enabled by default.

Configuring the GUI for HTTPS

You can protect communication with the GUI by enabling HTTPS. HTTPS protects HTTP browser
sessions by using the Secure Socket Layer (SSL) protocol. When you enable HTTPS, the controller
generates its own local Web Administration SSL certificate and automatically applies it to the GUI.
You can also load an externally generated certificate. Follow the instructions in the
Externally Generated HTTPS Certificate" section on page 2-4
generated certificate.
Using the CLI, follow these steps to enable HTTPS:
Enter show certificate summary to verify that the controller has generated a certificate:
Step 1
>show certificate summary
Web Administration Certificate................. Locally Generated
Web Authentication Certificate................. Locally Generated
Certificate compatibility mode:................ off
Step 2
(Optional) If you need to generate a new certificate, enter this command:
>config certificate generate webadmin
After a few seconds the controller verifies that the certificate is generated:
Web Administration certificate has been generated
Enter this command to enable HTTPS:
Step 3
>config network secureweb enable
Save the SSL certificate, key, and secure web password to NVRAM (non-volatile RAM) so your changes
Step 4
are retained across reboots:
>save config
Are you sure you want to save? (y/n) y
Configuration Saved!
Reboot the controller:
Step 5
>reset system
Are you sure you would like to reset the system? (y/n) y
System will now restart!
The controller reboots.
OL-9141-03
config network webmode {enable | disable}
config network secureweb {enable | disable}
Cisco Wireless LAN Controller Configuration GuideCisco Access Router Wireless Configuration Guide
Enabling Web and Secure Web Modes
"Loading an
for instructions on loading an externally
2-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sfe2000p440244042000 series2100 series

Table of Contents