Logging Out Of The Cli; Navigating The Cli - Cisco SD2008T-NA Configuration Manual

Using the CLI
Follow these steps to log into the CLI through the serial port:
Verify that your terminal emulator or DOS shell interface is configured with these parameters:
Step 1
•
•
Step 2 Use the controller IP address to Telnet to the CLI.
Step 3 At the prompt, log into the CLI. The default username is admin and the default password is admin.

Logging Out of the CLI

When you finish using the CLI, navigate to the root level and enter logout. The system prompts you to
save any changes you made to the volatile RAM.

Navigating the CLI

The is organized around five levels:
Root Level
Level 2
Level 3
Level 4
Level 5
When you log into the CLI, you are at the root level. From the root level, you can enter any full command
without first navigating to the correct command level.
CLI and to perform common tasks.
Table 2-1
Command
help
?
command ?
exit
Ctrl-Z
save config
reset system
2-8
Ethernet address
Port 23
Commands for CLI Navigation and Common Tasks
Cisco Wireless LAN Controller Configuration GuideCisco Access Router Wireless Configuration Guide
Chapter 2 Using the Web-Browser and CLI Interfaces
Table 2-1 lists commands you use to navigate the
Action
At the root level, view system-wide navigation
commands
View commands available at the current level
View parameters for a specific command
Move down one level
Return from any level to the root level
At the root level, save configuration changes from
active working RAM to non-volatile RAM
(NVRAM) so they are retained after reboot
At the root level, reset the controller without
logging out
OL-6415-01OL-9141-03