Using The Cli To Configure Ccx Radio Management - Cisco SD2008T-NA Configuration Manual

Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Follow the instructions in
Step 6
below to enable access point customization.
Note
Step 7 If desired, repeat this procedure for the other radio band (802.11a or 802.11b/g).

Using the CLI to Configure CCX Radio Management

Follow these steps to enable CCX radio management using the controller CLI.
Enter this command to globally enable CCX radio management:
Step 1
config advanced {802.11a | 802.11b} ccx location-meas global enable interval_seconds
The range for the interval_seconds parameter is 60 to 32400 seconds, and the default value is 60 seconds.
This command causes all access points connected to this controller in the 802.11a or 802.11b/g network
to issue broadcast radio measurement requests to clients running CCXv2 or higher.
Enter these two commands to enable access point customization:
Step 2
•
•
Enter this command to enable or disable location calibration for a particular client:
Step 3
config client location-calibration {enable | disable} client _mac interval_seconds
Note
Enter this command to save your settings:
Step 4
save config
OL-1926-06OL-9141-03
Step 2
To enable CCX radio management for a particular access point, you must enable access point
customization, which can be done only through the controller CLI.
config advanced {802.11a | 802.11b} ccx customize Cisco_AP {on | off}
This command enables or disables CCX radio management features for a particular access point in
the 802.11a or 802.11b/g network.
config advanced {802.11a | 802.11b} ccx location-meas ap Cisco_AP enable interval_seconds
The range for the interval_seconds parameter is 60 to 32400 seconds, and the default value is 60
seconds. This command causes a particular access point in the 802.11a or 802.11b/g network to
issue broadcast radio measurement requests to clients running CCXv2 or higher.
You can configure up to five clients per controller for location calibration.
of the "Using the CLI to Configure CCX Radio Management"
Cisco Wireless LAN Controller Configuration Guide
Configuring CCX Radio Management Features
section
10-31