Using The Cli To Configure The Service-Port Interface; Configuring Dynamic Interfaces; Using The Gui To Configure Dynamic Interfaces - Cisco SD2008T-NA Configuration Manual

Chapter 3 Configuring Ports and Interfaces

Using the CLI to Configure the Service-Port Interface

Follow these steps to display and configure the service-port interface parameters using the CLI.
Step 1 Enter show interface detailed service-port to view the current service-port interface settings.
Note
Enter these commands to define the service-port interface:
Step 2
•
•
•
The service port is used for out-of-band management of the controller. If the management workstation
Step 3
is in a remote subnet, you may need to add a route on the controller in order to manage the controller
from that remote workstation. To do so, enter this command:
config route network-ip-addr ip-netmask gateway
Enter save config to save your changes.
Step 4
Enter show interface detailed service-port to verify that your changes have been saved.
Step 5

Configuring Dynamic Interfaces

This section provides instructions for configuring dynamic interfaces using either the GUI or CLI.

Using the GUI to Configure Dynamic Interfaces

Follow these steps to create new or edit existing dynamic interfaces using the GUI.
Click Controller > Interfaces to access the Interfaces page (see
Step 1
Perform one of the following:
Step 2
•
•
•
OL-9141-03
The service-port interface uses the controller's factory-set service-port MAC address.
To configure the DHCP server: config interface dhcp service-port ip-address-of-primary-dhcp-
server [ip-address-of-secondary-dhcp-server]
To disable the DHCP server: config interface dhcp service-port none
To configure the IP address: config interface address service-port ip-addr ip-netmask gateway
To create a new dynamic interface, click New. The Interfaces > New page appears (see
Go to Step 3.
To modify the settings of an existing dynamic interface, click the interface's Edit link. The
Interfaces > Edit page for that interface appears (see
To delete an existing dynamic interface, click the interface's Remove link.
Configuring Dynamic Interfaces
Figure 3-5).
Figure 3-7). Go to
Cisco Wireless LAN Controller Configuration Guide
Figure 3-6).
Step 5.
3-15