Cisco SD2008T-NA Configuration Manual page 193

Chapter 6 Configuring WLANsWireless Device Access
To define the maximum value for the priority tag (0–7) associated with packets that fall within the
Step 11
profile, choose 802.1p from the Protocol Type drop-down box and enter the maximum priority value in
the 802.1p Tag field.
The tagged packets include LWAPP data packets (between access points and the controller) and packets
sent towards the core network.
Click Apply.
Step 12
Click Save Configuration.
Step 13
Reenable the 802.11a and 802.11b/g networks.
Step 14
To enable the radio network, click Wireless > 802.11a > Network or Wireless > 802.11b/g > Network,
check the 802.11a (or 802.11b/g) Network Status check box, and click Apply.
Using the CLI to Configure QoS Profiles
To configure the Platinum, Gold, Silver, and Bronze QoS profiles using the CLI, follow these steps.
Disable the 802.11a and 802.11b/g networks so that you can configure the QoS profiles. Enter these
Step 1
commands:
config 802.11a disable network
config 802.11b disable network
To change the profile description, enter this command:
Step 2
config qos description {bronze | silver | gold | platinum} description
Step 3 To define the average data rate in Kbps for TCP traffic on a per user basis, enter this command:
config qos average-data-rate {bronze | silver | gold | platinum} rate
Step 4 To define the peak data rate in Kbps for TCP traffic on a per user basis, enter this command:
config qos burst-data-rate {bronze | silver | gold | platinum} rate
To define the average real-time rate in Kbps for UDP traffic on a per user basis, enter this command:
Step 5
config qos average-realtime-rate {bronze | silver | gold | platinum} rate
To define the peak real-time rate in Kbps for UDP traffic on a per user basis, enter this command:
Step 6
config qos burst-realtime-rate {bronze | silver | gold | platinum} rate
To specify the maximum percentage of RF usage per access point, enter this command:
Step 7
config qos max-rf-usage {bronze | silver | gold | platinum} usage_percentage
To specify the maximum number of packets that access points keep in their queues, enter this command:
Step 8
config qos queue_length {bronze | silver | gold | platinum} queue_length
Step 9 To define the maximum value for the priority tag (0–7) associated with packets that fall within the
profile, enter this commands:
config qos protocol-type {bronze | silver | gold | platinum} dot1p
config qos dot1p-tag {bronze | silver | gold | platinum} tag
OL-1926-06OL-9141-03
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
6-21