Using The Gui To Perform A Link Test - Cisco SD2008T-NA Configuration Manual

Chapter 7 Controlling Lightweight Access Points

Using the GUI to Perform a Link Test

Follow these steps to run a link test using the GUI.
Click Wireless > Clients to access the Clients page (see
Step 1
Figure 7-11
Click the LinkTest link for the desired client. A link test page appears (see
Step 2
Note
OL-9141-03
Clients Page
You can also access this screen by clicking the Detail link for the desired client and then clicking
the Link Test button on the top of the Clients > Detail page.
Figure 7-11).
Cisco Wireless LAN Controller Configuration Guide
Performing a Link Test
Figure 7-12).
7-29