Cisco SD2008T-NA Configuration Manual page 192

Configuring WLANs
To disable the radio network, click Wireless > 802.11a > Network or Wireless > 802.11b/g > Network,
uncheck the 802.11a (or 802.11b/g) Network Status check box, and click Apply.
Step 2 Click Controller > QoS > Profiles to access the QoS Profiles page.
Click Edit for the specific profile you want to configure (see
Step 3
Figure 6-5
To change the description of the profile, modify the contents of the Description field.
Step 4
To define the average data rate for TCP traffic on a per user basis, enter the rate in Kbps in the Average
Step 5
Data Rate field. A value of 0 disables this option.
To define the peak data rate for TCP traffic on a per user basis, enter the rate in Kbps in the Burst Data
Step 6
Rate field. A value of 0 disables this option.
To define the average real-time rate for UDP traffic on a per user basis, enter the rate in Kbps in the
Step 7
Average Real-Time Rate field. A value of 0 disables this option.
To define the peak real-time rate for UDP traffic on a per user basis, enter the rate in Kbps in the Burst
Step 8
Real-Time Rate field. A value of 0 disables this option.
In the Maximum RF usage per AP (%) field, enter the maximum percentage of air bandwidth given to a
Step 9
user class.
For example if you set 50% for Bronze QoS, all the Bronze WLAN users combined will not get more
than 50% of available RF bandwidth. Actual throughput could be less than 50%, but it will never be more
than 50%.
Step 10 In the Queue Depth field, enter the number packets that access points keep in their queues. Any
additional packets are dropped.
Cisco Wireless LAN Controller Configuration Guide
6-20
Controller > Edit QoS Profiles Page
Chapter 6 Configuring WLANsWireless Device Access
Figure 6-5).
OL-1926-06OL-9141-03