Using The Cli To Configure Rf Groups; Viewing Rf Group Status; Using The Gui To View Rf Group Status - Cisco SD2008T-NA Configuration Manual

Viewing RF Group Status

Using the CLI to Configure RF Groups

Follow these steps to configure an RF group using the CLI.
Enter config network rf-network-name name to create an RF group.
Step 1
Note
Enter show network to view the RF group.
Step 2
Enter save config to save your settings.
Step 3
Step 4 Repeat this procedure for each controller that you want to include in the RF group.
Viewing RF Group Status
This section provides instructions for viewing the status of the RF group through either the GUI or the
CLI.
You can also view the status of RF groups using the Cisco Wireless Control System (WCS). Refer to the
Note
Cisco Wireless Control System Configuration Guide for instructions.

Using the GUI to View RF Group Status

Follow these steps to view the status of the RF group using the GUI.
Click Wireless to access the All APs page (see
Step 1
Cisco Wireless LAN Controller Configuration Guide
10-8
Enter up to 19 ASCII characters for the group name.
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Figure 10-2).
OL-1926-06OL-9141-03