Using The Cli To Configure Mfp - Cisco SD2008T-NA Configuration Manual

Chapter 5 Configuring Security Solutions
Figure 5-8
Under Management Frame Protection, this page shows the level of MFP protection and validation.

Using the CLI to Configure MFP

Use these commands to configure MFP using the controller CLI.
1.
2.
3.
OL-9141-03
802.11a Cisco APs > Configure Page
To enable or disable MFP globally for the controller, enter this command:
config wps mfp {enable | disable}
If MFP is enabled globally for the controller and you want to disable or re-enable it for a particular
WLAN, enter this command:
config wlan mfp protection {enable | disable} wlan_id
If MFP is enabled globally for the controller and you want to disable or re-enable it for a particular
access point, enter this command:
config ap mfp validation {enable | disable} Cisco_AP
Configuring Management Frame Protection
Cisco Wireless LAN Controller Configuration Guide
5-17