Using The Cli To Configure The Virtual Interface - Cisco SD2008T-NA Configuration Manual

Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Enter these commands to define the AP-manager interface:
Step 4
•
•
•
•
•
Enter save config to save your changes.
Step 5
Enter show interface detailed ap-manager to verify that your changes have been saved.
Step 6

Using the CLI to Configure the Virtual Interface

Follow these steps to display and configure the virtual interface parameters using the CLI.
Step 1 Enter show interface detailed virtual to view the current virtual interface settings.
Step 2 Enter config wlan disable wlan-number to disable each WLAN that uses the virtual interface for
distribution system communication.
Step 3 Enter these commands to define the virtual interface:
•
•
Step 4 Enter reset system. At the confirmation prompt, enter Y to save your configuration changes to NVRAM.
The controller reboots.
Step 5 Enter show interface detailed virtual to verify that your changes have been saved.
Cisco Wireless LAN Controller Configuration Guide
3-14
config interface address ap-manager ip-addr ip-netmask gateway
config interface vlan ap-manager {vlan-id | 0}
Enter 0 for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
Note
that only tagged VLANs be used on the controller.
config interface port ap-manager physical-ds-port-number
config interface dhcp ap-manager ip-address-of-primary-dhcp-server
[ip-address-of-secondary-dhcp-server]
config interface acl ap-manager access-control-list-name
See Chapter 5 for more information on ACLs.
Note
config interface address virtual ip-address
For ip-address, enter any fictitious, unassigned, and unused gateway IP address, such as
Note
1.1.1.1.
config interface hostname virtual dns-host-name
Chapter 3 Configuring Ports and Interfaces
OL-9141-03