Using The Cli To Configure Dynamic Rrm - Cisco SD2008T-NA Configuration Manual

Configuring Dynamic RRM
Table 10-1 RRM Parameters (continued)
Parameter
Click Apply to commit your changes.
Step 3
Click Save Configuration to save your changes.
Step 4
Step 5 Repeat this procedure to set the same parameter values for every controller in the RF group.

Using the CLI to Configure Dynamic RRM

Follow these steps to configure dynamic RRM using the CLI.
Enter this command to disable the 802.11a or 802.11b/g network:
Step 1
config {802.11a | 802.11b} disable
Perform one of the following:
Step 2
•
•
•
Cisco Wireless LAN Controller Configuration Guide
10-22
Signal Measurement
Coverage Measurement
To have RRM automatically configure all 802.11a or 802.11b/g channels based on availability and
interference, enter this command:
config {802.11a | 802.11b} channel global auto
To have RRM automatically reconfigure all 802.11a or 802.11b/g channels one time based on
availability and interference, enter this command:
config {802.11a | 802.11b} channel global once
To specify the channel set used for dynamic channel allocation, enter this command:
config advanced {802.11a | 802.11b} channel {add | delete} channel_number
You can enter only one channel number per command. This command is helpful when you know that
the clients do not support certain channels because they are legacy devices or they have certain
regulatory restrictions.
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Description
How frequently the access point measures signal strength and how
frequently neighbor packets (messages) are sent, which eventually
builds the neighbor list.
Range: 60 to 3600 seconds
Default: 60 seconds
How frequently the access point measures the coverage area and passes
this information to the controller.
Range: 60 to 3600 seconds
Default: 180 seconds
OL-1926-06OL-9141-03