Using The Cli To Configure Enhanced Distributed Channel Access; Using Management Over Wireless; Using The Gui To Enable Management Over Wireless - Cisco SD2008T-NA Configuration Manual

Using Management over Wireless

To verify that the controller is properly configured, log back into the CLI and enter show 802.11b to
Step 7
view these parameters:
802.11b Network................................ Enabled
Short Preamble mandatory....................... Disabled
These parameters show that the 802.11b/g network is enabled and that short preambles are disabled.

Using the CLI to Configure Enhanced Distributed Channel Access

Use this CLI command to configure 802.11 enhanced distributed channel access (EDCA) parameters to
support SpectraLink phones.
Using Management over Wireless
The Cisco UWN Solution Management over Wireless feature allows operators to monitor and configure
local controllers using a wireless client. This feature is supported for all management tasks except
uploads to and downloads from (transfers to and from) the controller.
Before you can use the Management over Wireless feature, you must properly configure the controller
using one of these sections:
•
•

Using the GUI to Enable Management over Wireless

Click Management > Mgmt Via Wireless to access the Management Via Wireless
Step 1
Check the Enable Controller Management to be accessible from Wireless Clients check
Step 2
selection box is not checked, continue with
Click Apply to commit your changes.
Step 3
Click Save Configuration to save your changes.
Step 4
Use a wireless client web browser to connect to the controller management port or DNS port IP address, and
Step 5
log into the controller GUI to verify that you can manage the WLAN using a wireless client.
Cisco Wireless LAN Controller Configuration Guide
5-6
config advanced edca-parameters {svp-voice | wmm-default}
where
svp-voice enables SpectraLink voice priority (SVP) parameters and
wmm-default enables wireless multimedia (WMM) default parameters
Note To propagate this command to all access points connected to the controller, make sure to
disable and then re-enable the 802.11b/g network after entering this command.
Using the GUI to Enable Management over Wireless, page 5-6
Using the CLI to Enable Management over Wireless, page 5-7
Chapter 5
Step 3. Otherwise, continue with
Configuring Security Solutions
page.
box. If the
Step 3.
OL-9141-03