Configuring Identity Networking - Cisco SD2008T-NA Configuration Manual

Configuring Identity Networking

5.
6.
Configuring Identity Networking
These sections explain the identity networking feature, how it is configured, and the expected behavior
for various security policies:
•
•
•
Cisco Wireless LAN Controller Configuration Guide
5-20
Stats Reporting Period .......................... 180
LED State........................................ Enabled
ILP Pre Standard Switch.......................... Disabled
ILP Power Injector............................... Disabled
Number Of Slots.................................. 2
AP Model......................................... AP1020
AP Serial Number................................. WCN09260057
AP Certificate Type.............................. Manufacture Installed
Management Frame Protection Validation .......... Enabled
To see MFP statistics for the controller, enter this command:
show wps mfp statistics
Information similar to the following appears:
BSSID Radio
---------------- -------
00:12:44:b0:6a:80 a
00:0b:85:56:c2:c0 b/g
00:14:1b:5b:fc:80 a
Use these commands to obtain MFP debug information:
debug wps mfp ?
where ? is one of the following:
lwapp—Shows debug information for MFP messages.
detail—Shows detailed debug information for MFP messages.
report—Shows debug information for MFP reporting.
mm—Shows debug information for MFP mobility (inter-controller) messages.
Identity Networking Overview, page 5-21
RADIUS Attributes Used in Identity Networking, page 5-22
Configuring AAA Override, page 5-25
Validator AP Name Invalid MIC
----------------- ------------
tester-1000b
tester-1000b
tester-1000b
Chapter 5 Configuring Security Solutions
Invalid Seq No MIC
------------ ------- ------
28 0 0
0 0 3
774 0 0
MIC
0
0
0
OL-9141-03