Cisco SD2008T-NA Configuration Manual page 183

Chapter 6 Configuring WLANsWireless Device Access
If you chose PSK in
Step 7
pre-shared key in the blank field. WPA pre-shared keys must contain 8 to 63 ASCII text characters or 64
hexadecimal characters.
Click Apply to commit your changes.
Step 8
Step 9 Click Save Configuration to save your changes.
Using the CLI to Configure WPA1+WPA2
Follow these steps to configure a WLAN for WPA1+WPA2 using the controller CLI.
Step 1 Enter this command to disable the WLAN:
config wlan disable wlan_id
Step 2 Enter this command to enable or disable WPA for the WLAN:
config wlan security wpa {enable | disable} wlan_id
Enter this command to enable or disable WPA1 for the WLAN:
Step 3
config wlan security wpa wpa1 {enable | disable} wlan_id
Enter this command to enable or disable WPA2 for the WLAN:
Step 4
config wlan security wpa wpa2 {enable | disable} wlan_id
Enter these commands to enable or disable AES or TKIP data encryption for WPA1 or WPA2:
Step 5
•
•
The default values are TKIP for WPA1 and AES for WPA2.
Enter this command to enable or disable 802.1X, PSK, or CCKM authenticated key management:
Step 6
config wlan security wpa akm {802.1X | psk | cckm} {enable | disable} wlan_id
The default value is 802.1X.
Step 7 If you enabled PSK in
config wlan security wpa akm psk set-key {ascii | hex} psk-key wlan_id
WPA pre-shared keys must contain 8 to 63 ASCII text characters or 64 hexadecimal characters.
Enter this command to enable the WLAN:
Step 8
config wlan enable wlan_id
Enter this command to save your settings:
Step 9
save config
OL-1926-06OL-9141-03
Step 6, choose ascii or hex from the PSK Format drop-down box and then enter a
config wlan security wpa wpa1 ciphers {aes | tkip} {enable | disable} wlan_id
config wlan security wpa wpa2 ciphers {aes | tkip} {enable | disable} wlan_id
Step 6, enter this command to specify a pre-shared key:
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
6-11