Cisco SD2008T-NA Configuration Manual page 73

Chapter 3 Configuring Ports and Interfaces
Table 3-2
Parameter
Power Over Ethernet (PoE)
Table 3-3
Step 3
make any desired changes.
Table 3-3
Parameter
Admin Status
Physical Mode
Link Trap
OL-9141-03
Port Status
Description
Determines if the connecting device is equipped to receive power
through the Ethernet cable and if so provides -48 VDC.
Values: Enable or Disable
Note
Note
lists and describes the port's configurable parameters. Follow the instructions in the table to
Port Parameters
Description
Enables or disables the flow of traffic through the port.
Options: Enable or Disable
Default: Enable
Note
Determines whether the port's data rate is set automatically or
specified by the user. The supported data rates vary based on
controller type.
Default: Auto
Controller
4400 series
2000 and 2100 series
WiSM
Catalyst 3750G Integrated
Wireless LAN Controller Switch
WLAN controller module
Causes the port to send a trap when the port's link status changes.
Options: Enable or Disable
Default: Enable
Some older Cisco access points do not draw PoE even if it is
enabled on the controller port. In such cases, contact the Cisco
Technical Assistance Center (TAC).
The controller in the Catalyst 3750G Integrated Wireless LAN
Controller Switch supports PoE on all ports.
Administratively disabling the port on a controller does not
affect the port's link status. The link can be brought down only
by other Cisco devices. On other Cisco products, however,
administratively disabling a port brings the link down.
Cisco Wireless LAN Controller Configuration Guide
Configuring Ports
Supported Data Rates
Auto or 1000 Mbps full duplex
Auto or 10 or 100 Mbps, half or
full duplex
Auto or 1000 Mbps full duplex
Auto or 1000 Mbps full duplex
Auto or 100 Mbps full duplex
3-21