Using The Cli To Change The Snmp Community String Default Values; Changing The Default Values For Snmp V3 Users - Cisco SD2008T-NA Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access

Using the CLI to Change the SNMP Community String Default Values

Follow these steps to change the SNMP community string default values through the controller CLI.
To see the current list of SNMP communities for this controller, enter this command:
Step 1
show snmp community
If "public" or "private" appears in the SNMP Community Name column, enter this command to delete
Step 2
this community:
config snmp community delete name
The name parameter is the community name (in this case, "public" or "private").
To create a new community, enter this command:
Step 3
config snmp community create name
Enter up to 16 alphanumeric characters for the name parameter. Do not enter "public" or "private."
Step 4 To enter the IP address from which this device accepts SNMP packets with the associated community,
enter this command:
config snmp community ipaddr ip_address ip_mask name
Step 5 To specify the access level for this community, enter this command, where ro is read-only mode and rw
is read/write mode:
config snmp community accessmode {ro | rw} name
To enable or disable this SNMP community, enter this command:
Step 6
config snmp community mode {enable | disable} name
Step 7 To save your changes, enter save config.
Step 8 Repeat this procedure if you still need to change the default values for a "public" or "private" community
string.

Changing the Default Values for SNMP v3 Users

The controller uses a default value of "default" for the username, authentication password, and privacy
password for SNMP v3 users. Using these standard values presents a security risk. Therefore, Cisco
strongly advises that you change these values.
SNMP v3 is time sensitive. Make sure that you have configured the correct time and timezone on your
Note
controller.
Ol-9141-03
Changing the Default Values for SNMP v3 Users
Cisco Wireless LAN Controller Configuration Guide
4-11