Using The Cli To Configure Aes Key Wrap - Cisco SD2008T-NA Configuration Manual

Configuring AES Key Wrap
Figure 5-19 RADIUS Authentication Servers > New Page
Click Apply.
Step 10
Click Save Configuration.
Step 11

Using the CLI to Configure AES Key Wrap

To configure a controller to use AES key wrap using the CLI, follow these steps.
To enable the use of AES key wrap attributes, enter this command:
Step 1
config radius auth keywrap enable
To configure AES key wrap attributes, enter this command:
Step 2
config radius auth keywrap add {ascii | hex} index
The index attribute specifies the index of the RADIUS authentication server on which to configure AES
key wrap.
Cisco Wireless LAN Controller Configuration Guide
5-40
Chapter 5 Configuring Security Solutions
OL-9141-03