Control Unit Configuration - Lucent Technologies MERLIN LEGEND Release 6.1 System Planning Manual
Release 6.1
Hide thumbs
Also See for MERLIN LEGEND Release 6.1:
- Feature reference (1021 pages) ,
- System programming manual (1010 pages) ,
- Maintenance and troubleshooting manual (510 pages)
Table of Contents
Advertisement
MERLIN LEGENDCommunications System Release 6.1
System Planning 555-661-112
2
Control Unit Configuration
Control Unit Configuration
2
After you have completed the preplanning tasks described in Chapter 1, "Before
You Begin", you can plan the control unit configuration. Planning the control unit
configuration consists of the following tasks:
1.
Planning Module Placement. Calculate the system's line/trunk and
extension capacity according to the number of module types; then map out
the placement of the modules on the Control Unit Diagram.
2.
Recording System Operating Conditions. Note the system's type of
programming equipment, it's mode and language choice, and whether the
Automatic Maintenance Busy feature is to be enabled or disabled.
3.
Numbering the System. Decide the order in which to connect the
telephones and other equipment to the control unit based on the
customer's needs and applications. Determine whether the
system-assigned extension numbers are appropriate for the customer's
business or if they need to be renumbered.
This chapter contains instructions for completing each of these tasks.
Issue 1
August 1998
Page 2-1
2
Advertisement
Table of Contents
Need help?
Do you have a question about the MERLIN LEGEND Release 6.1 and is the answer not in the manual?