Upgrading To Release 6.1 - Lucent Technologies MERLIN LEGEND Release 6.1 System Planning Manual
Release 6.1
Hide thumbs
Also See for MERLIN LEGEND Release 6.1:
- Feature reference (1021 pages) ,
- System programming manual (1010 pages) ,
- Maintenance and troubleshooting manual (510 pages)
Table of Contents
Advertisement
MERLIN LEGENDCommunications System Release 6.1
System Planning 555-661-112
7
Upgrading
Upgrading to Release 6.1
Upgrading to Release 6.1
This section contains an overview of upgrading from Releases 1.0, 1.1, 2.0, 2.1,
3.0, 3.1, 4.0, 4.1, 4.2, 5.0, and 6.0 to Release 6.1.
Upgrade Overview
To upgrade to Release 6.1, you must back up, convert, and restore system
programming information. Any version of SPM may be used to perform the
system back up. To convert and restore the system programming back up file,
SPM Version 6.25 or later must be used. You must also have (or install) a
processor module with a PCMCIA memory card slot, and a forced installation
PCMCIA memory card with Release 6.1 system software.
NOTE:
NOTE:
NOTE:
The version of SPM packaged with Intuity does not support conversion. The
most current version of SPM is available for download from NSAC.
Perform the following tasks:
1.
Back up the system programming.
2.
Install SPM Version 6.25 or later (if not already installed).
3.
Refer to
Release 6.1 format. If required, convert the backup file. Check the warning
messages regarding Setup Space; determine if you want to accept the files
as Setup Space or not.
4.
Power down the system.
5.
If the system already has a processor module with a PCMCIA memory card
slot installed, proceed to
in Slot 0 then continue this procedure with
6.
If a new processor module was installed in
insert a Release 6.1 forced installation memory card into the PCMCIA
memory card slot on the processor module.
7.
Power up the system. If the Release 6.1 forced installation card was
inserted in
8.
Restore the system programming.
9.
Program new features.
For more detailed information and procedures (including error conditions and
recovery as well as procedures for translation conversion), see Maintenance and
Troubleshooting , System Programming and Maintenance, and System
Programming .
Table 7–1
to determine if the backup file needs to be converted to
Step
Step
6, a frigid start will occur.
7
7
6. Otherwise, install a new processor module
Step
7.
Step
5, go to
Issue 1
August 1998
Page 7-2
Step
7. Otherwise,
Advertisement
Table of Contents
