Selecting Line/Trunk Options - Lucent Technologies MERLIN LEGEND Release 6.1 System Planning Manual

MERLIN LEGENDCommunications System Release 6.1
System Planning 555-661-112
3 Lines/Trunks

Selecting Line/Trunk Options

Selecting Line/Trunk Options
You can select the following options for the incoming trunks connected to the
system:
Loop-Start Reliable Disconnect
Outmode Signaling
Toll-Call Prefix Dialing Requirements (Toll Type)
Hold Disconnect Interval
QCC Operator to Receive Calls (Hybrid/PBX mode only)
QCC Queue Priority (Hybrid/PBX mode only)
Pools
Remote Access
DS1 Connectivity
Tie Trunks
DID Trunks
NI-1 BRI Connectivity
NOTE: NOTE: NOTE:
If incoming trunks are part of a private network, the Switch Identifier must
also be programmed. See the Network Reference for information.
This section contains instructions for selecting line/trunk options for incoming
trunks. In addition, because some systems outside of the US have slow dial tones
from their local telephone companies, this section also includes instructions for
compensating for slow dial tone.
Forms Needed
Form 1, System Planning
Form 2c, System Numbering: Line/Trunk Jacks
Form 3a, Incoming Trunks: Remote Access
Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
Form 3c, Incoming Trunks: Tie
Form 3d, Incoming Trunks: DID
Form 3i, Incoming Trunks: BRI Options (800 NI-BRI module)
3
Issue 1
August 1998
Page 3-11
3