Integrated Administration - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures

Integrated Administration

Console Display/Instructions
Assign or remove the 2B data pair.

Select
Enter
Delete.
Return to the System Programming menu.

Select two times.
Exit
Integrated Administration
NOTE: NOTE: NOTE:
This feature applies only to Release 2.0 or later of the communications
system.
Integrated Administration is available in Hybrid/PBX and Key modes only.
Capabilities
The Integrated Administration capability of Integrated Solution III (IS III) simplifies
the programming of common information for the communications system (the
switch), AUDIX Voice Power and, if it is installed, the AT&T FAX Attendant
System . Since the AUDIX Voice Power and FAX Attendant applications use
some of the same information programmed on the switch, Integrated
Administration lets the installer or system manager make changes or additions to
this information just once, instead of on both sides of the connection. Using
Integrated Administration reduces programming time and effort and ensures that
the switch and the applications are in agreement.
Common Information
The switch and the applications share the following information:
System numbering of extensions, trunks, and pools
System labeling of the user (or other input name) associated with each
extension, trunk, and pool
The coverage Group that sends its calls to the applications
The calling group set up for each service of the applications
The Reliable Disconnect setting for loop-start trunk
The Delay Ring and Coverage Delay Interval settings
The Transfer Return Time and VMS Transfer Return Interval settings
or
Additional Information
You may continue to assign or remove additional
2B Data pairs by repeating Steps 4 and 5.
4
4
4
Issue 1
June 1997
Page 4-364
PC