Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 555

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
PRI Facilities
PRI B-channel groups programmed for line routing perform similarly to loop-start
trunks. PRI B-channel groups programmed for dial plan routing perform similarly
to DID trunks.
NOTE: NOTE: NOTE:
If more lines than B-channels are assigned to a B-channel group, users
may experience situations where a line that is idle is not able to seize a
B-channel. The user receives a fast busy tone.
Summary: B-Channel Groups
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To program a single line/trunk:
PC Procedure
System Manager
Hybrid/PBX, Key
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
Not applicable
Group numbers (1 to 80)
Yes
No
LinesTrunks PRI
group no.
Enter
nos.
Enter Lines
Dial line/trunk no.
Mode
To program a block of lines/trunks:
LinesTrunks PRI
group no.
Enter
no.
Enter Lines
specific lines/trunks
On/Off
Exit Exit
To program a single line/trunk:
slot and port nos.
no. Type line/trunk
no.
To program a block of lines/trunks:
slot and port nos.
specific lines/trunks
On/Off
4
B-ChannlGrp B Channels
Dial B-channel slot and port
Dial group no.
Enter
Enter Exit
B-ChannlGrp B Channels
Dial B-channel slot and port
Dial group no.
Enter
Toggle LED
Exit
Type group no.
Type group
Type group no.
Type group no.
Toggle letter
G
Issue 1
June 1997
Page 4-148
Dial
E
ntry
Exit Exit
Dial
Select
Type B-channel
Type B-channel
Select