Dial Plan Routing - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
PRI Facilities
Console Display/Instructions
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select three times.
Exit

Dial Plan Routing

Dial plan routing provides a way to route incoming calls on a "per B-channel
group" basis. An incoming call is routed by matching the incoming number (by
service, number of digits, and pattern) and then optionally deleting and/or adding
digits to direct the call to a specific endpoint. A service must be specified; the
number of digits and pattern are optional. For example, you can specify that calls
received from a particular area code should be routed to the specific individual or
group responsible for accounts in that area.
Dial plan routing is available in Hybrid/PBX mode only. Key systems route
incoming calls on a per-line basis.
In Release 4.2 and later, you can specify the following additional services:
MCI Toll Services available for a DMS-250 or DEX600E switch type:
Local exchange carrier services available for a DMS-100 switch type:
NOTES:
1.You can enter a service not shown on the Network Service screen by
using the five-digit binary code that represents the service in the Network
Facilities Information Element of ISDN PRI layer three signaling protocol.
( Contact your service provider for more information about the codes.)
See "Miscellaneous Procedures."
— MCI PRISM
— MCI Vnet
— MCI 800
— MCI 900
— DMS Private
— DMS INWATS
— DMS OUTWATS
— DMS FX (foreign exchage)
— DMS Tie Trunk
Additional Information
4
Issue 1
June 1997
Page 4-176
PC