Basic System Operating Conditions - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures

Basic System Operating Conditions

Basic System Operating Conditions
The procedures in this section are all related to the system rather than to the
operation of telephones, operator positions, lines, or trunks.
NOTE: NOTE: NOTE:
You must reset the system time when Daylight Savings Time begins and
ends.
This section contains the following programming procedures:
System Programming Position Assignment
System Language
System Date
System Time
System Programming Position Assignment
Use this procedure to reassign the extension used for system programming. This
extension should not be the same extension as that used for the operator position.
The system programming position can be reassigned only to one of the first five
extension jacks on the first MLX module. Only one system programming console
is allowed per system.
If you are programming on the console, be aware of the following:
The console must be connected to the extension currently assigned for
system programming.
As soon as you change the system programming extension, the system
programming session is terminated. To proceed with system programming,
you must connect the system programming console to the newly assigned
extension and enter system programming again.
NOTE: NOTE: NOTE:
The telephone used for system programming must be an MLX-20L.
Summary: System Programming Position
Assignment
Programmable by
Mode
Idle Condition
Planning Form
System Manager
All
Not required
Form 1, System Planning
3
3
3
Issue 1
June 1997
Page 3-3