Terminal Equipment Identifier - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
PRI Facilities
Console Display/Instructions
Erase the current setting.

(Display depends on
timer/counter
selected).
Backspace
Exit
Enter the new setting (see

Dial or type [ nnnn ].
Continue to assign the setting to another slot or go to Step 11.

Select .
Next
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select four times.
Exit

Terminal Equipment Identifier

Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
!
Summary: Terminal Equipment Identifier
Programmable by
Mode
Idle Condition
Additional Information
Next
Press Drop.
Enter
Table 4-2).
CAUTION:
The value of the TEI rarely has to be changed. Check with your
Lucent Technologies representative before changing this value.
System Manager
All
Not required
Return to Step 8. The next slot will be
displayed on Line 1.
4
4
Issue 1
June 1997
Page 4-173
PC
+
Ã