Time Control - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
Night Service
Enter the time of day as four digits, using 24-hour notation. Enter the day of the
week as a single digit (0 to 6), with 0 being Sunday. If you enter an invalid
number, the system truncates the number.
If you change the system time while Night Service is active, Night Service is
deactivated automatically and you must manually reactivate it.
Operators can override the timer and turn Night Service on and off manually. This
feature can be deactivated when extraordinary situations occur (for example, a
midweek holiday).
NOTE: NOTE: NOTE:
For Release 2.1 and earlier, after setting Start and Stop time for Night
Service you must use the following procedure to set the current day of the
week for Night Service.
NightSrvce
If system programming information is being loaded into memory from a backup
diskette, the current day of the week must be reset.
Night Service can be turned off by using the following procedure:
NightSrvce
Summary: Night Service with Time Set
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure To add or change start/stop time:
Dial the current day of the week
Day of Week
Dial
Day of Week
System Manager
All
Not required
Form 9c, Night Service: Time Set
Not applicable
Day: 0 to 6; Time: 0000 to 2359
No
No
NightSrvce Start
time
Enter
time
Enter
To activate/deactivate:
NightSrvce

Time Control

9 Enter Exit
3
Drop Dial start day and
Drop Dial stop day and
Stop
Exit
Off
Issue 1
June 1997
Page 3-214
Enter Exit
or
On Enter Exit