Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 466

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Console/Display Instructions
Assign or remove the LS-ID Delay.

Select
Enter
Delete
Return to the System Programming menu.

Select twice.
Exit
Block Procedure
Specify the block of 20 lines associated with the 20 line buttons

on the system programming console.
Select
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Assign the LS-ID Delay to the appropriate lines/trunks.

Return to the System Programming menu.

Select twice.
Exit
Clock Synchronization
Use this procedure to specify the primary, secondary, and tertiary clock source. A
clock source may be either a 100D module or a port on an 800 NI-BRI module.
See Feature Reference for more information about the appropriate setting. If the
clock is taken from a 100D module, you can also specify whether the clock is
synchronized to the external endpoint (loop) or to the clock reference source
(local).
NOTE: NOTE: NOTE:
This procedure is necessary only if your system includes an 800 NI-BRI
module or more than one 100D module.
or
.
Additional Information
You may continue to assign or remove the
LS-ID delay from additional lines/trunks by
repeating Steps 2 and 3.
Toggle the green LED on or off as required.
On = assign the LS-ID Delay
Off = remove the LS-ID Delay
4
Issue 1
June 1997
Page 4-59
PC