Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 463

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Lines and Trunks
Block Procedure
Console/Display Instructions
Specify the block of 20 lines associated with the 20 line buttons

on the system programming console.
Select
Lines 01-20
Lines 21-40
Lines 41-60
Lines 61-80
Assign or remove the lines for the specified QCC operator.

Return to the System Programming menu.

Select twice.
Exit
Loop-Start Identification Delay
Use this procedure to delay the alerting (ringing) of calls arriving on loop-start
lines/trunks connected to an 800 GS/LS-ID module at all extensions until
approximately six seconds have elapsed since the port module informed the
system software that the line was ringing, or the system software has been
informed that Caller ID information is available, whichever comes first.
This option can be programmed on a per-trunk basis. It gives the appearance to
the users that the Caller-ID information is available the moment the call arrives at
the extension, and prevents applications or adjuncts from answering the call too
soon.
The LS-ID Delay setting appears on the Ground-Start/Loop-Start Trunk
Information report.
Any extension or adjunct that answers an incoming CO line on the first ring
causes the Caller ID information associated with the call to be lost. The adjunct
must be programmed to either answer the call on the second (or later) ring, or
delay the call. The call can be delayed either by setting the ring option on the
buttons associated with the adjunct or by using the LS-ID Delay option.
NOTE: NOTE: NOTE:
Caller-ID information is not available on ground-start lines/trunks.
Additional Information
Toggle the green LED on or off as required.
On = operator receiving calls
Off = operator not receiving calls
4
Issue 1
June 1997
Page 4-56
PC