Lines And Trunks - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures

Lines and Trunks

Lines and Trunks
The procedures in this section are used to assign optional features to individual
lines and trunks. The following optional features can be assigned:
Type of Trunk
Outmode Signaling for Loop- or Ground-Start Trunks
Rotary Trunk Digit Transfer
Disconnect Signaling Reliability
Toll Type
Hold Disconnect Interval
Principal User for Personal Line
QCC Queue Priority
QCC Operator to Receive Calls
Incoming Call Line Identification Delay
Trunks to Pools Assignment
The Copy Options feature (described at the end of this section) allows you to copy
several optional features from an idle trunk. This option eliminates the need to
individually enter each feature.
Separate sections cover "DS1 Facilities," "Tie Trunks," "DID Trunks," "PRI
Facilities," and "BRI Facilities."
A slot is the physical location of the individual module on the control unit. There is
a maximum of 17 slots which are numbered as follows:
Basic carrier: slots 1 through 5
First expansion carrier: slots 6 through 11
Second expansion carrier: slots 12 through 17
A port is a line or trunk jack on the module. Individual modules support different
numbers of ports. On any module, port 1 is the lowest physical jack position. Lines
connect equipment to the switch and trunks connect a switch to a switch. Lines
and trunks have logical IDs, unique numeric identifiers for each extension and
trunk jack in the communications system control unit. Lines are numbered from 1
to 144, while trunks are numbered from 801 to 880. An MLX extension port has 2
logical IDs for each physical jack.
4
Issue 1
June 1997
Page 4-26