Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 101

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
2 Programming with SPM
Accessing SPM
Set the Programming Language
If you prefer to program in a language other than the current SPM language
setting, see ''Language''.
Modem Connections
You must make a data connection to a modem. The following modem dialing
commands are for Hayes and Hayes-compatible modems. These may not be the
commands your modem uses refer to the user guide that came with your
modem for specific information.
If the PC is in the same location as the control unit, type
If the PC is in a remote location and your system has activated the Remote
Access feature, type the following and press
The password prompt appears on the screen when the connection is
made. (You may have to press
prompt.)
If the PC is in a remote location and your system has not activated the
Remote Access feature, do the following:
NOTE: NOTE: NOTE:
If you enter a telephone number of fewer than 11 digits, you must end it with
a pound sign (#).
To access SPM through a local or remote modem connection, follow the steps
below.
Set up the appropriate physical connections between the PC and the control

unit. See ''Connecting the
— Without barrier codes type:
; the remote access telephone number; and
ATDT
For example:
ATDT12015551234 W*10
— With barrier codes type:
; the remote access telephone number; the barrier code
ATDT
preceded by a "W" and
is 555555.
For example:
ATDT12015551234 W555555 W*10
— Use the main telephone number to place a voice call to the system
on the line to which the modem is connected.
— Instruct the operator to transfer you to the modem (by pressing
Transfer, dialing
— To put the modem on line, type
up the telephone.
PC''.
. The barrier code in the example below
W*10
more than once to get the password
, then hanging up the telephone).
*10
and press
ATH1
Issue 1
June 1997
Page 2-17
.
*10
:
.
W*10
.
.
, then hang
2
2