E&M Signal - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Tie Trunks
Console Display/Instructions
Return to the System Programming Menu.

Select two times.
Exit
E&M Signal
Use this procedure to specify the type of tie trunk signal, as follows:
E&M Mode:
Simplex Mode:
Summary: E&M Signal
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
— 1S. Type 1 Standard. Tie trunks that are connected through the
local telephone company.
— 1C. Type 1 Compatible. Tie trunks that are connected directly to a
system that uses 1S signaling.
— 5. Type 5 Simplex. Tie trunks that are connected to a system using
Type 5 signaling.
System Manager
All
Tie trunk idle
Form 3c, Incoming Trunks: Tie
1S
1S, 1C, 5
No
Yes
LinesTrunks
no.
Enter
type
Additional Information
4
4
TIE Lines E&M Signal
Specify signaling type
Type trunk no.
Issue 1
June 1997
Page 4-110
PC
Dial trunk
Enter Exit Exit
Specify signaling