Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual page 278

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
3 Common Administrative Procedures
Optional Group Features
Group Calling Member Assignments
Use this procedure to assign or remove an extension to or from a calling group. A
calling group is used to direct calls to a group of people who all handle the same
type of call. A single extension number is assigned to the group and is used by
both inside and outside callers to reach the group.
To reassign an extension to a new calling group, you must remove it from its old
group before programming the new assignment.
NOTE: NOTE: NOTE:
If a linear hunting pattern is indicated on the back of the system planning
form (6d), be sure to assign extensions to the group in the exact order that
they are shown on the form. The system searches for an available member
in the order in which you assign the extensions to the group.
A maximum of 32 calling groups with a maximum of 20 extensions per
group is allowed.
An extension can belong to only one calling group. A QCC cannot be a
member of a calling group. A delay announcement device should not be
programmed as a calling group member.The extension status feature must
be set to the Calling Group or CMS mode before you assign members to
the group. See "Extension Status."
Summary: Group Calling Member Assignments
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Manager
All
Not required
Form 7c, Group Coverage
Not applicable
Extension numbers
Yes
No
More
Extensions
group ext. no.
Enter
no.
Enter Exit
no. Type ext. no.
3
3
Grp Calling Members
Dial ext.
Exit Exit
Type calling group ext.
Issue 1
June 1997
Page 3-124
Dial calling