Sub A Frl; Facility Restriction Level - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
Automatic Route Selection
Save your entry.

Select .
Enter
Return to the System Programming menu.

Select twice.
Exit

Facility Restriction Level

Use this procedure to assign a Facility Restriction Level (FRL) to each route. The
FRL ranges from 0 (least restrictive) to 6 (most restrictive) and is used to restrict
user access to the route. The FRL assigned to telephones and remote access
users is the opposite of the FRL assigned to routes, where 0 is the most restrictive
and 6 is the least restrictive.
NOTE: NOTE: NOTE:
Pool routes must be programmed before you assign Facility Restriction
Levels.
Facility Restriction Levels are assigned to Tables 1 through 18. Tables 17 and 18,
the Default Toll and Default Local tables respectively, cannot be changed.
Summary: Facility Restriction Level
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System Manager
Hybrid/PBX
Not required
Form 3f, Automatic Route Selection Tables
Form 3g, Automatic Route Selection Default and Special
Numbers Tables
3 (beginning with Release 3.1, Table 18, the Default Local
table has a factory setting of 2)
0 to 6
No
No
Tables ARS

Sub A FRL

table no, and pool route no.
level
Enter Exit
or
route no. Type restriction level
4
4
or More and
Sub B FRL
Dial restriction
Enter
Exit
Type table no. and pool
and
Issue 1
June 1997
Page 4-327
Dial