Telephone Number To Send - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming Manual

MERLIN LEGEND Communications System Release 5.0
System Programming 555-650-111
4 Programming Procedures
PRI Facilities

Telephone Number to Send

Use this procedure to assign the telephone number to send to the network when
outgoing calls are made on an ISDN line. If the person being called subscribes to
an automatic number identification service, the number indicates who is calling.
The number assigned to each channel does not have to be unique because it is
not used for routing.
The telephone number sent to the network can be the one of the following:
The extension number assigned to the calling telephone (Select
Extension Only
The extension number substituted into the lower order digits of a
systemwide base number (Select
The facility-based line telephone number (Select
in Step 4)
NOTE: NOTE: NOTE:
Only one base number is supported per system. In systems having
non-uniform extension numbers, for example, where there are some
three-digit extension numbers and some four-digit extension numbers, one
base number may not be sufficient to represent all the external telephone
numbers of all extensions.
Summary: Telephone Number to Send
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
in Step 4)
System Manager
All
Not required
Form 3b, Incoming Trunks: DS1 Connectivity
(100D module)
No digits are assigned
Up to 12 digits (any combination of 0 to 9)
No
No
LinesTrunks PRI
no. Drop
Enter
no. Drop
Enter
no.
Enter Exit
Specify type of no.
Type base no.
no.
4
Base Number with Ext
Line Telephone Number
4
Specify type of
NumbrToSend
Dial base no.
Enter
Dial telephone
Exit
+ Type telephone
Issue 1
June 1997
Page 4-163
in Step 4)
Dial line
+