Hard Disk Drive - Avaya Nortel Communication Server 1000 Reference

Hard disk drive

The CP PM hardware can be used as a platform for the CS 1000 Signaling Server. When
deployed as a signaling server, the CP PM platform is equipped with a hard disk drive.
Note:
The hard drive must have its jumper set for CSEL operation before installation.
Install a hard drive on a Nortel CP PM Signaling Server
This section describes the procedure for installing a hard drive on both models of the Nortel
CP PM Signaling Server (NTDW61BAE5 and NTDW66AAE5). A Nortel CP PM Signaling
Server Hard Drive kit (NTDW6102E5) ships with the servers, and if required, can also be
ordered from Nortel.
The hard drive kit contains a hard drive with a jumper, 4 screws, and installation instructions
(document N0120776). You need only a small Phillips screw driver to install the hard drive.
Important:
IMPORTANT!
Observe proper ESD precautions while handling the hard drive and Nortel CP PM server.
Use the following procedure to replace the hard drive on a Nortel CP PM server.
Replacing the hard drive on a Nortel CP PM Signaling Server
1. Ensure jumper is located in the cable select (CS) position according to the labeling
Circuit Card Reference
on the hard drive.
Media storage
July 2011 627