Zmodem Startup; Debug Mode - Neoware c50 - Thin Client User Manual

ZMODEM Startup

Resource: xteemx340*zmodemStartup: on/off
Command Line: -zm
+zm off
Default Setting: Off
When ZMODEM startup is enabled, TeemTalk will check incoming data for a remote
ZMODEM startup sequence then automatically start a file transfer using the settings
specified in the ZModem Settings dialog box. Note that the transfer protocol
selected in the Initiate File Transfer dialog box will be ignored. Refer to the File
Transfer chapter for more information.

Debug Mode

Resource: xteemx340*debugMode
Command Line: -debug
Default Setting: Not applicable
In debug mode, TeemTalk will print characters received from the host on stderr as
well as actioning them, and you can display information on particular keys or key
combinations when you press them.
The format of the information displayed when a key or key combination is pressed is
as follows:
Keycode = 13, State = 0, Keysym = 65471
where the Keycode is the hardware code assigned to the physical key, State
indicates whether the key was pressed in conjunction with a modifier key (e.g. caps
lock, shift), and Keysym is the unique keysym value assigned to the key or key
combination.
This is useful for finding keysym values which can be directly used in Translation
tables, as shown in the following example where 65471 is the keysym value for F2
on the Sun 4 keyboard:
*xteemx340*vt220.Translations: #override \n\
Resources & Command Line Options
on
<Key>65471: string ("This is the F2 key")
25-11