Hp700/92 Emulation; Introduction; Keyboard Mapping - Neoware c50 - Thin Client User Manual

HP700/92 Emulation

This chapter describes features of the Hewlett Packard 700/92 terminal
emulation.

Introduction

The emulation of the Hewlett Packard 700/92 terminal is entered by displaying the
Emulation Settings dialog box from the Settings menu and setting the Alpha
Emulation option to HP70092. Clicking Ok will close the dialog box and TeemTalk
will be in HP700/92 mode, as indicated by the following row of buttons displayed
along the bottom of the window.
These buttons indicate the current function of keys F1 through F8 on the keyboard
and are described in the Buttons & Function Keys section following the keyboard
mapping illustrations overleaf. The two numbers in the middle button indicate the
current line and column position of the cursor. The display area is 80 columns wide
by 24 lines deep by default, and 72 lines are stored off-screen. You can toggle
between 80 and 132 column display by pressing the function key F12.
The HP700/92 emulation is configured for host communications via the HP70092
Settings dialog box which is described in the Setup Menus chapter.
The following sections provide information on keyboard mapping, how to use the on-
screen buttons and equivalent function keys, programming keys, and how to specify
character display attributes.

Keyboard Mapping

The following illustrations show where HP700/92 keyboard functions are mapped to
keys on the Enhanced AT, Sun 5, Sun 4 and HP 9000 series keyboard layouts.
HP700/92 Emulation
12
12-1