Neoware c50 - Thin Client User Manual page 40

Getting Started
The MDI P9 emulation provides compatibility with software designed to drive the
McDonnell Douglas Prism-9 terminal.
The PT250 emulation provides compatibility with software designed to drive the
Prime PT250 terminal. Refer to the PT250 Emulation chapter for details.
SCO-CONSOLE is an emulation of the SCO UNIX box.
The Siemens 97801 emulation provides compatibility with software designed to drive
the Siemens 97801 terminal. Refer to the Siemens 97801 Emulation chapter for details.
The STRATUS V102 emulation provides compatibility with software designed to
drive the Stratus V102 terminal.
The TA6530 emulation provides compatibility with software designed to drive the
Tandem 6526 and 6530 terminals. You must make a host connection using the Telnet
facility supplied with TeemTalk in order for this mode to function correctly in block
mode applications. Refer to the TA6530 Emulation chapter for details.
The TVI 910+, 920 and 925 emulations provide compatibility with software
designed to drive the TeleVideo 910+, 920 and 925 terminals, respectively, as
emulated by the Wyse WY-50/50+/60 terminals. Refer to the Wyse Emulations
chapter for more details.
The TVI 950 and TVI 955 emulations provide compatibility with software designed
to drive the TeleVideo 950 and 955 terminals, respectively.
The Viewdata 40, Viewdata 80 and Viewdata Split modes enable access to a
viewdata service using one of three display formats, as described in the Viewdata
Mode section later.
The VT52 and VT100 emulations enable you to run applications written for the DEC
VT52 and VT100 terminals, respectively. Refer to the DEC VT Emulations chapter
for more information.
The VT400 Series-7 and VT400 Series-8 emulations enable you to run applications
written for the DEC VT400 terminal, the difference is in their treatment of 8-bit
control codes. When VT400 Series-7 is selected, all 8-bit codes are converted to
their 7-bit equivalents, whereas VT400 Series-8 leaves 8-bit codes unchanged. If you
are using VT200 applications, select VT400 Series-7. Refer to the DEC VT
Emulations chapter for more information.
The WYSE 50, 50+ and 60 emulations provide compatibility with software designed
to drive the Wyse WY-50, WY-50+ and WY-60 terminals, respectively. Refer to the
Wyse Emulations chapter for information on these emulations.
3-8