Neoware c50 - Thin Client User Manual page 106

Setup Menus
The STRATUS V102 emulation provides compatibility with software designed to
drive the Stratus V102 terminal.
The TA6530 emulation provides compatibility with software designed to drive the
Tandem 6526 and 6530 terminals. You must make a host connection using the Telnet
facility supplied with TeemTalk in order for this mode to function correctly in block
mode applications. Refer to the TA6530 Emulation chapter for details.
The TVI 910+, 920 and 925 emulations provide compatibility with software designed
to drive the TeleVideo 910+, 920 and 925 terminals, respectively, as emulated by the
Wyse WY-50/50+/60 terminals. Refer to the Wyse Emulations chapter for more
details.
The TVI 950 and TVI 955 emulations provide compatibility with software designed
to drive the TeleVideo 950 and 955 terminals, respectively.
The Viewdata 40, Viewdata 80 and Viewdata Split modes enable access to a
viewdata service using one of three display formats, as described in the Viewdata
Mode section in the Getting Started chapter.
The VT52 and VT100 emulations enable you to run applications written for the DEC
VT52 and VT100 terminals, respectively. Refer to the DEC VT Emulations chapter for
more information.
The VT400 Series-7 and VT400 Series-8 emulations enable you to run applications
written for the DEC VT320 terminal, the difference is in their treatment of 8-bit
control codes. When VT400 Series-7 is selected, all 8-bit codes are converted to their
7-bit equivalents, whereas VT400 Series-8 leaves 8-bit codes unchanged. If you are
using VT200 applications, select VT400 Series-7. Refer to the DEC VT Emulations
chapter for more information.
The WYSE 50, 50+ and 60 emulations provide compatibility with software designed
to drive the Wyse WY-50, WY-50+ and WY-60 terminals, respectively. Refer to the
Wyse Emulations chapter for information on these emulations.
Graphic Emulation
Factory default: ReGIS
This option is only available in versions of TeemTalk that support graphics
emulations. The setting determines the graphics mode that will be entered when the
host sends graphics commands.
The 4010/4014 emulation enables you to run applications written for the Tektronix
4010 and 4014 terminals.
The Regis emulation enables you to run applications written for the DEC VT340
terminal in ReGIS mode.
The VT640 emulation enables you to run applications written for the Retrographics
VT640 terminal.
The Westward 2119 emulation enables you to run applications written for the
Westward 2119 terminal.
8-32