Neoware c50 - Thin Client User Manual page 89

Setup Menus
When you achieve a TN3270E connection, the LU device name that you are con-
nected as will be displayed on the status line. If the specified device is rejected by the
server or host, then an error message box will be displayed indicating the reason.
Associate
This is available when the Model option in the IBM 3270 Settings dialog box is set to
3287-1 (a printer). It is used to request that the device name of the printer associated
with a particular terminal is assigned to this Telnet session. The name of the terminal is
specified here. (This is implemented as described in RFC 1647.)
TN3270E Options
TN3270E in implemented as described in RFC 1647. These options should not be
changed unless required by your System Administrator.
The Bind setting determines whether or not the server is allowed to send the SNA
Bind image and Unbind notification to the emulator.
When Responses is selected, positive and negative response handling is supported. It
allows the server to reflect to the emulator any and all definite, exception, and no
response requests sent by the host application.
When SysReq is selected, some (or all, depending on the server) of the functions of
the SysReq key will be emulated and the server in an SNA environment.
The LU1 and LU3 Printer options are available when the Model option in the IBM
3270 Settings dialog box is set to 3287-1 (a printer). They enable you to specify
which printer type(s) to support.
Seconds Before Print Close
Factory default: 0
The setting of this option determines when TeemTalk completes a print job. When set
to 0, TeemTalk will not start printing until it receives a 'print end of job' command
from the host. Entering any other number will cause TeemTalk to print after the speci-
fied number of seconds have elapsed, regardless of whether or not the 'print end of job'
command has been received from the host.
8-15