Wyse Settings - Neoware c50 - Thin Client User Manual

Wyse Settings

This dialog box is displayed by selecting Wyse in the Settings menu. Note that some
of the settings apply to the TVI 910+, TVI 920, TVI 925, ADDS A2 and HZ 1500
emulations in addition to the Wyse emulations. Also, some settings may not apply to
the particular Wyse emulation currently running. Selecting a setting that is not
applicable to the current emulation will cause TeemTalk to use the default setting for
that emulation when the dialog box is exited.
Lines
Factory default: 24
This option applies to the WY-50+ and WY-60 emulations and specifies the number
of data lines displayed on the screen below the status line. Note that the other
emulations only support 24 lines and a label line.
24
25
42
43
Page Size
Factory default: 1 x Lines
This option applies to the WY-50+ and WY-60 emulations and specifies the size of a
page in display memory in multiples of the Lines setting. Note that the other
emulations only support 1 x Lines.
24 data lines and a label line at the bottom.
25 data lines but no label line.
42 data lines and a label line at the bottom.
43 data lines but no label line.
Setup Menus
8-59