Neoware c50 - Thin Client User Manual page 136

Setup Menus
When selected, a new page of memory will be displayed.
Note: The other emulations do not support multiple pages, so the
DEL = DestBS
Factory default: Unselected
This option applies to the WY-50+ and WY-60 emulations and determines what effect
an ASCII DEL character has on displayed characters. The other emulations ignore the
DEL character.
When unselected, the DEL character is ignored. When selected, the DEL character is
interpreted as a destructive backspace, causing the character to the left of the cursor to
be deleted and the cursor to move into that position.
Margin Bell
Factory default: Unselected
This option applies to all emulations and specifies whether or not an audible warning
sounds when the cursor reaches a specified column. The default bell column number is
72 in 80 column mode and 124 in 132 column mode.
Enhance
Factory default: Selected
When this option is selected, TeemTalk will recognize an additional set of Wyse codes
for the Hazeltine 1500 and ADDS Viewpoint emulations which are not normally
supported by these terminals.
Answerback Mode
Factory default: Unselected
This option applies to all emulations and specifies whether or not an answerback mes-
sage is automatically sent to the host in response to an ASCII ENQ character.
Send ACK
Factory default: Selected
This option applies to all emulations and specifies whether or not an ASCII ACK
character is sent to the host port after certain commands have been executed.
Block Mode
Factory default: Unselected
This option applies to all emulations. In Block mode, keyboard entered data is
displayed and processed locally, allowing you to edit it before a block of data is sent to
the host. When Block mode is disabled, data is sent to the host as it is entered at the
keyboard.
8-62
cursor moves according to the Auto Scroll option.