Neoware c50 - Thin Client User Manual page 139

Setup Menus
Print By Pass
This option is available when the Model option is set to a printer. The Start Seq box
enables you to enter the character or sequence of characters that initiate a print bypass.
The end sequence that terminates the print bypass can be specified either by entering
the actual characters in the End Seq box when Specify End Sequence is selected, or
by specifying the number of characters that make up the end sequence in the End
Length box when End On Non-Hex is selected.
If no End Seq is entered, the bypass is assumed to be for a single pair of characters
only. If an End Seq is specified, characters in the data stream between the start and end
are interpreted as encoded ASCII. For example, "1B0A" becomes ASCII 27 10 (ESC
LF).
Selecting End on Non-Hex enables you to specify the number of characters that make
up the end sequence in the End Length box. The bypass will then terminate as soon as
a non-hexadecimal character is received (any character except in the range 0 through 9
and A through F) followed by the end sequence.
Characters can be entered in several ways. For example, to specify the ASCII escape
character, you can enter either _027, \u001B, \e, \033, or even ^[.
Ruler Type
Factory default: Cross
A rule can be displayed across the emulation workspace at the cursor position by
holding down the modifier key Alt, Meta or Extend Char and pressing Page Down,
which toggles it on and off. The setting of this option determines whether it is
displayed as a horizontal rule, vertical rule or both (cross).
Follows Cursor
Factory default: Unselected
When the rule is displayed in the emulation workspace, the setting of this option deter-
mines whether or not the rule follows the cursor when it moves.
Include Euro Character
Factory default: Unselected
When this option is selected, the International Currency symbol will be replaced by the
Euro symbol.
8-65