Neoware c50 - Thin Client User Manual page 91

Setup Menus
Where a device name collision occurs (i.e. the device name is already in use on the
host) the host will ask again for the device name during the same connection. In this
case TEST1, TEST2, ... may all be tried in one connection until the host accepts one,
or all possibilities have been tried. In the latter case the same name is sent twice in
succession to indicate to the host all names have been tried.
If concurrent 5250 sessions are started before a previous session has negotiated an
acceptable device name, it is possible that the two sessions will access the counter
simultaneously and not all possible names will be tried by each session. This should
not cause a problem unless the separate sessions use different modulo values (for
example, session one device name TEST%d4% and session two device name
ANOTHER%d100%) or are connecting to different hosts.
Note: There are separate counters for the IBM 3270 and IBM 5250
emulations.
User , Password , Library , Menu
These options enable you to specify the initial entries required on the standard startup
screen so that it can be bypassed. Each entry can be a maximum of ten characters.
Program
This enables you to specify the name of the initial program to run. The entry can be a
maximum of ten characters.
8-17