Neoware c50 - Thin Client User Manual page 312

Resources & Command Line Options
The -geometry = option may be abbreviated to -g =.
Note: The effect of these commands is determined by the window
The command is followed by the size and location arguments, which take the
following form:
widthxheight±xoffset±yoffset
The values for each of the four variables are specified as numbers of pixels. A
positive offset will position the left or top edge of the window a specified pixel
distance from the left or top edge of the display, while a negative offset will position
the right or bottom edge of the window a specified pixel distance from the right or
bottom edge of the display.
If any of the values are omitted, TeemTalk will use the resource manager defaults for
the missing values. If no location defaults are specified by the resource manager, the
user will have to position the window manually.
The default size of the initial window is 800 x 500 pixels for TeemTalk with graphics
support, and 640 x 400 pixels for TeemTalk without graphics, in which 80 columns by
25 lines (24 text lines and 1 status line) is displayed.
Command line example:
xteemx340 -g =320x240-50+75
This will cause a window 320 pixels wide and 240 pixels high to be offset 50 pixels
from the left of the display and 75 pixels from the bottom of the display.
It is recommended that the window size is specified using the Window Size (Col-
umns/Lines) commands described in the next section rather than geometry.
Window Size (Columns/Lines)
Resource:
Command Line: -dc number of columns
Resource:
Command Line: -dl number of lines
Default Setting: Not applicable (size defined by geometry).
These commands allow the default TeemTalk window size to be defined by the
number of columns and lines. The overall window size is calculated using the default
font for TeemTalk unless the font is overridden by other font specifications. If the size
of the window is attempted to be set by both geometry and -dc and/or -dl, then the
geometry setting will be used.
25-20
manager which may have its own rules for window size and
position on the display.
xteemx340*defaultColumns: number of columns
xteemx340*defaultLines: number of lines