Wyse Emulations; Introduction; Display Format - Neoware c50 - Thin Client User Manual

This chapter describes features of the Wyse WY-50, WY-50+ and
WY-60 terminal emulations.

Introduction

The emulation of the Wyse WY-50, WY-50+ or WY-60 terminal is entered by
displaying the Emulation Settings dialog box from the Settings menu and setting the
Alpha Emulation option to Wyse 50, Wyse 50+ or Wyse 60. TeemTalk also supports
the Wyse emulations of the TeleVideo 910+, 920 and 925, ADDS Viewpoint A2, and
Hazeltine 1500 terminals, selectable via the same dialog box option.
All the Wyse associated emulations are configured via the Wyse Settings dialog box
which is described in the Setup Menus chapter. Note that some settings may not
apply to the particular emulation currently running. Selecting a setting that is not
applicable to the current emulation will cause TeemTalk to use the default setting for
that emulation when the dialog box is exited.

Display Format

The display is divided into three areas by default: the status line, the data area, and the
label line.
At the top of the screen is the status line which is used to display information relating
to the emulation and messages from the application. The following section describes
the status messages that can be displayed by the emulation.
The data area is where data entered from the keyboard or the application is displayed.
The data area is set to 24 lines by 80 columns by default.
The label line is displayed at the bottom of the screen when the data area is set to 24
or 42 lines. This is can be used to display messages or function key labels defined by
the host.

Wyse Emulations

Wyse Emulations
21
21-1